I have the following spare parts for sale, all parts are used and are in great condition.

Weldon 23456-A that has just been rebuilt by Weldon. The pump is dated 08/19/05 and is in perfect condition. This pump will handle all of your fueling needs. $900.00.

Short block with billet main caps and filled. Set up for 1/2" head studs. $1000.00

Short block with billet main caps and filled. Also has JE FSR pistons, Carillo H-Beam rods stock cranks, ARP main studs and is set up for 1/2" main studs. $3000.00.

5 stage Barnes dry sump pump. $700.00

5 stage Barnes dry sump pump with oil manifold. $800.00

Spearco water to air intercooler single inlet/outlet with self contained pump and lines and filler cap on top. $900.00

Fluidyne small drag racing Radiator with built in electric water pump. $600.00

Fluidyne small drag racing radiator brand new. $250.00

East West triple 7.5" clutch set up for 2JZ with spare parts. $3500.00

AFT Pressure plate and spare discs and floaters. $1500.00

Trik Titanium bellhousing with titanium liner and set up for cross shaft t.o. bearing. $2700.00

G-Force 2000 transmission with spare gears and Long shifter. $5200.00

If your building a race car here is a chance to get many expensive hard to find parts for your car right away. Get a head start and save a lot of money.

More info on the block would be great.
Does the block need to be bored? Whats the current bore?
What spec bearings are the mains setup for? Oversized or OE?


Also, would you be willing to sell just the billet main caps?

More info on the block would be great.
Does the block need to be bored? Whats the current bore?
What spec bearings are the mains setup for? Oversized or OE?


Also, would you be willing to sell just the billet main caps?

The blocks are in .20 and .40 over. You let me know which size you prefer and if I still have it available in those sizes you are welcome to it. I believe I have 2 that are .20 over and six that are .40 over.

We used all factory Toyota bearing in the mains if that answers your question.

I won't take the billet main caps off of a motor that has already had them installed, that doesn't make any sense to do that but I have plenty of main capss that are new and have not been machined yet, If you are interested in the Main caps alone this is the way you would need to buy them and I will sell you those for $500.00 a set brand new.

I also have a diaper for a 2JZ for sale made by Taylor. I think every class needs one of these next year so you should step up and buy this one and be prepared, plus you can save some money.

$350.00

Craig, do you have an email address where I can get in touch with you? Interested in a few of the parts you have up for sale.

Thanks

Sure, paisturbo@aol.com

Craig, let me know if whats the deal with the blocks. If you have what Im looking for I would like to pick one up.

Let me know.