87mk3suprT
10-18-2005, 03:53 PM
Hey guys,
well I'm new to this forum but not new to the supra sence. I have been rebuilding my engine for the better part of a year and some how after moving twice I lost a bunch of the bolts. I need the bolt specs for just about everything that attaches to the motor, any info would be greatly appreciated
ma71supraturbo
10-19-2005, 08:06 PM
What bolts are you looking for?
87mk3suprT
10-22-2005, 10:05 PM
Pressure plate, bellhouse, motor mounts, and all the acessorie mounts
flubyux2
10-23-2005, 03:32 AM
pressure plate uses 10mm bolts, same as 4AGE.
bell housing uses 10mm bolts, forget the thread pitch. i think its 1.25. there are 4 long ones, about 4" long. there are 2 more for the starter, they are 8mm i think, similar length as the 4 bell housing bolts. the 2 cast iron brackets that brace the block to the lower part of the bell housing use 4 more 10mm bolts i beleive.
the accessory mounting is going to be hard. you may just have to use whatever youve got in your bucket of bolts, just make sure you get enough thread engagment to securely fasten you stuff. if it only threads in 1 turn and gets tight, its obviously too short. itd suck to use the wrong bolt and have your PS pump fall off. also, besure to not use bolts that are too long and bottom out in the hole before tightening the accessory to the block. it can be hard to find the right bolt, but its safer.
next time, either put the bolts/nuts back into the holes the came from, or keep them with the accessory that they held on. slide the bolts into the holes of whatever tab or bracket they are for, and wrap tape around it to keep the bolt fromf alling out. it definitly helps out in the long run
kamil
10-30-2005, 01:51 PM
http://7mpower.com/kamil/Mk3EngineFasteners.pdf
Loki89t
10-30-2005, 03:19 PM
http://7mpower.com/kamil/Mk3EngineFasteners.pdf
That is awesome!