Hey folks,

I tried selling this one over on SM without a lot of luck, so here we go again...

Turbonetics T-61 T-series turbo
Water and oil passages
Ceramic BB center section
Polished compressor cover
Undivided .81 tangential turbine housing
.60 compressor cover
4" inlet, 2.5" outlet
3" V band clamp on the back

Paid $1900 new for it and I am willing to take the best offer! Please feel free to make any offer. It really needs to go to make room for my SP61GT!!! It has 1500 documented miles on it with 8 dyno pulls. No issues with the turbo, but it doesn't fit in the car with an HKS old style manifold...

what did you make on those 8 pulls?

I was running only 16 psi and was making 390 rwhp and about the same torque. It doesn't sound like much, but the turbo wasn't even working hard at that pressure. A/F was still high 10's, so still rich, and EGT's were staying below 1000 degrees. There was still a lot of potential, but I had a boost controller issue that wasn't allowing more than 16 psi. I really love the turbo, but I'm going back to a more bolt-on setup with an internal gate. It was really operating in a very efficient, reliable part of the compressor map. Currently taking any reasonable offer, MUST GO!