Hey guys. I have a 4 row that is set up for a single turbo, however, the single will not go on for a couple more months due to some set backs.
I've read that it's possible to still use this kit w/ stock twin set up, using parts of the factory intercooler piping. I've searched everywhere, but cannot find any more information in regards to tips or "how to's" on this one.
Chris, I know that HPF states that this is possible too ... any help on what pipes to use? I've tried playing with all the pipes (in different sequence) and I just don't see how this would work :confused: . Any help would be appreciated!

David,
IIRC, you use some intake pipes not positive which ones anymore you put them on the turbo side. Go to the Supra forums and search for 4rows/stock twins. I wrote a few posts way back when I had mine hooked up.

The pipes aren't pretty they barely fit and with the bumper off look like ass. They do work though you have to play with them over and over till they form a makeshift setup. The pipes through the fender well stay keep those there and then play with the intake side pipes on the turbo side. I ended up heating up the big elbow to make it fit the 4row then clamped it down. The elbow that tapers off goes to the turbo side of the core thats the one that needs to be heated to fit at least mine did to fit properly. From that elbow you must use a hard plastic one so you can clamp them together and from there it gets foggy.

.... the intake side will have the regular 4row piping.

http://www.supraforums.com/forum/showthread.php?t=93831&highlight=4row+piping

http://www.supraforums.com/forum/showthread.php?t=93831&highlight=4row+piping

Thank you so much for the help :D . I had been confused, and now can see how it should work. Thanks again :cheers: .
When you ran w/ stock twins and a 4 row, the stock piping was fine?

Thank you so much for the help :D . I had been confused, and now can see how it should work. Thanks again :cheers: .
When you ran w/ stock twins and a 4 row, the stock piping was fine?

We did that and everything was fine. You just use the driver side stock piping on the passenger side.

Chris.

You are welcome!
No, I had no issues with them blowing apart you could use hairspray if your worried. Just spray the connections.