grr, after installing my boost gauge,ive realized ive blown a fuse or two, somehow...

i need to know the locations for the fuses of my dash lights(speedo/tach/fuel level lights)
and the fuse for my parking lights...

also my foglights no longer work, so all i have is headlights now..

any ideas? there is a chance that its more than just fuses....

it could be there is always a possibiblity butt the fusses ur looking for r in the kick panel on left side of foot area on driver side of car

haha thanks. yeah the fuse panel for JDM models are on the driver side but on the right side of the car =D

ill see what the labels say when its light out again.

thanks man

my TAIL lights are also out.

i have brake lights, but no tail lights when driving like.. when my headlights are on.

Typically, that's due to a fault in the taillamp failure module. Usually the damage is quite obvious. Try opening the box up and see if there are any burnt traces, typically you'll find either a burnt jumper (which can sometimes be replaced) or you'll find a big hole where the PCB has been burnt through.

found the fuse in my kick panel, it was the one i hadnt checked because...im lazy? haha


but yeah, everything works now, but i did take off the lamp failure sensor and took it apart and the circit board is like burnt and corroded.

i got a price check here, and a new one is gonna cost my 102$??

sheesh, i think i'd rather have a little light on in my dash. -_-

and i was wondering if you guy had any spare lamp failure sensors just laying around that i could buy from you for a reasonable price

pm me if so, =D


thanks

You should post the part number. There are a few different versions of the Lamp Failure Module. FYI, most of the versions will cause your taillights to stop working if certain parts of it do burn up.

ill post the part number in a few hours.

well my tailights work now, its just that annoying little light in my dash =/

all exterior lights on my car are functioning...so im assuming its the actual sensor.

gemme a few to go outside and get the part No.